Getting some ideas in mind for spring/summer cycle 2008.
I'm 22yr. old--6' 2" 225 lbs. Roughly 18-22% body fat

Anything that i could add that would make a major difference

Wks 1-11: Test. Enanthate 500mgs
Wks 1-14: Eq. 400mgs
Wks 9-15: Masteron 200mgs E3D
Wks 1-15: Hcg 500 iu E3D
Wks 16-17: Clomid 150mgs (daily-wk 16) 100mgs (daily wk 17)

I would add A-sin for 6 weeks wks 16-21. That will help you out A LOT for you're pct. You may also want to run an AI throughout to keep your androgen receptors from becoming over saturated. Visions made a thread which stated how when estrogen becomes too high it can affect androgen receptors.

Just some food for thought. You may or may not want to run a low dose of t3 to help shed some of that bf% you're looking to drop with this. Just remember that your diet will be the biggest factor in achieving the look you want and you'll need carbs if you want your T3 to work well.

what would a good dose of the t-3 be and would the t-3 be a better choice than clenbuterol.

Now everyone is different but I as well as the majority hold a lot of water with Test Enathate. If your looking to get cut that water could hide the cuts.

Try Test Prop or Sust. If your running proviron then you should be fine with Enanthate.

With the T3 Dosage, I would start at 25mcg/day and then you can work your way up with the dosage until you find what works best for you.

jcanaan2057 wrote:what would a good dose of the t-3 be and would the t-3 be a better choice than clenbuterol.

I would pyramid the dose up from 25mcg ED to as much as 75mcg ED but you may not need to go any higher than 50mcg. You'll want to pyramid back down and be sure to take in carbs after the fact to help get your thyroid bouncing back.

clen and T3 are wayyyyyyy different in the fact that they target 2 totally different things. Clen is a B2 antagonist and T3 is a thyroid med so they work differently but betw the 2 T3 is much more severe and yields far better results when the diet is dialed in.

also what are the goals you are trying to accomplish with this cycle? i am assuming lean mass?